Product Details

Light Bars are available in four profiles - 27mm, 32mm, 38mm and 52mm diameters - as shown above. Typical spacings for the fibre tails are between 50mm and 100mm.

Light Bars can be supplied as a straight tube with the fibre tails emerging from one or both ends, or can be manufactured as part of a gantry system.

A range of mounting brackets for bars can be supplied. End caps are also available to cover the hole at the end of the bar.

Our range of Light Bars are made to order, to the sizes you specify, and come as standard in either black or white or they can be powder coated to your specified RAL colour.

The UFO34D eyeball is always supplied in black, however the trumpets can be painted to a custom colour to match the light bar.

Common End Connectors

Light Bars can be supplied with either standard 30mm or mini 12.5mm common ends. Where a mini common end is used, a 30mm adaptor is required to fit a standard light source.

Mini common ends allow for more than one independently removable tube to be connected to a light source and require a smaller hole to pass through for easier installation. A maximum of three 12.5mm mini common ends can be connected to one 30mm common end.

Light Bars using 2mm or 3mm fibre in fittings with optional 1.5mm or 1.8mm points for infill with a single 30mm mini common end and tails from one end:

When using a mini common end connector, the maximum tails per bar is ten of 3mm fibre or 26 of 2mm fibre. Where infill points* are used, reduce the maximum number of fittings proportionally.