Manufactured from round aluminium extrusion, our fibre optic light tubes are available in 3 diameters; 32mm, 38mm and 52mm.

They can be custom painted any RAL colour to match your specification or can be supplied in raw finish. They are also available in polished stainless steel to special order.

Fibre points are installed along the length of the tube at spacings specified. The points can either be in one line or can be staggered to allow them to cover a wider area.

Light Tubes can be supplied with either standard 30mm or mini 12.5mm or 14mm common ends. Where a mini common end is used, a 30mm adaptor, as shown below, is required to fit a standard light source.

Mini common ends allow for more than one independently removable tube to be connected to a light source and require a smaller hole to pass through for easier installation. A maximum of three 12.5mm mini common ends and two 14mm mini common ends can be connected to one 30mm common end.

Maximum points of light per light tube, when lit from one end using a standard 30mm common end.

Maximum points of light per light tube, when lit from one end using a mini common end.

A number of different types of accessory brackets are available for Light Tubes.

The Round Brackets are for vertical or horizontal mounting of tubes/bars. The tube is locked with a grub screw. They are also available round with either one straight side or two straight sides to allow mounting as close as possible to a flat surface or in a corner.

Square Brackets are for surface mounting tubes horizontally or vertically and come as split halves.

Clip Brackets allow for horizontal mounting and the stand-off can be extended using threaded rod. These can be fitted on site to both tubes and bars.

Aa well as the brackets detailed below, we can incorporate light tubes into gantry systems, allowing them to be stood off from the mounting surface.